Slab Heat Cable PDF E-mail

Amuheat Slab Heat Cable In Slab Underfloor Heating System

Overview


Amuheat Slab Heat Cable Underfloor Heating System

Amuheat’s Elektra Slab Heat underfloor heating system uses heating cables embedded in a concrete slab floor to provide comfort radiant heating. Suitable for new constructions and renovations for both small and large areas and suitable for new constructions and renovations as an in-slab heating system under many different flooring surfaces including polished concrete, stone, tiles (ceramic and vinyl) parquetry and low pile carpet.
 
The slab acts as a heat storage bank which warms up during off-peak times (at night) - while heat dissipates from the slab throughout the day. The system can also be set to come on for a pre-determined at-day rate as heating requirements increase towards the end of the day.

Manufactured using only the finest materials, the tough AS/NZS compliant heating cable features a heating conductor with XLPE insulation, AL/PET Tape, Copper tinned braid & a final PVC outer Sheath.

Elektra Slab Heat floor heating cable is available with a twin conductor heating cable in varying lengths, packaged on reels - which allow a kink and twist-free roll out.

Features


  • Available in ready made sets for trade or DIY install
  • Waterproof cold tail connections
  • Fully earthed floor heating element
  • Maintenance free
  • Thermostatically controlled
  • Allergy friendly - produces no VOC's (Volatile Organic Compounds)
  • Healthy, produces no harmful EMR (Electro Magnetic Radiation)
  • Manufacturers guarantee



Technical



Application: Direct & background floor heating for installation in-concrete (in-slab). Suited for use directly beneath most hard floor surfaces
Installation: In concrete (in-slab) or 25mm cement-based screed
Heating Element: Twin heating conductor with full earth screen. Twin heating element diameter varies from 5,2 mm x 7,2 mm to 6,4 mm x 8,8 mm.2mm. 2 Metre factory terminated cold tail.
Voltage: 240 Volt AC.
Output Power: 35 W/m
Control: Programmable room or floor sensing (or a combination of both) control
Safety: IEC60335 compliant and wired into an earthed power supply connected through a RCD circuit.
Quality: DIN EN ISO 9001:2000 standards
Cold Tail Length: 2 metre factory terminated tails
Safety:  IEC compliant
Slab Heat Warranty:  5 years


Installation



In-Slab
Slab Heat Cable Underfloor heating



Trade Kits


 
Slab Heat CableSlab Heat Cable underfloor heating kits include: Twin heating cable packaged on a reel with factory fitted cold tail leads, cable clips for fixing to mesh, pliers,  element fault monitor, digital programmable thermosat (with built in timer, air sensor, floor probe sensor, 16A relay), installation guide, telephonic technical & installation support.

Slab Underfloor Heating Kits


Downloads



   Slab Heat Cable Data Specification
          (inslab)

   AT8100V Programmable Thermostat Data Sheet
          (vertical mount, touch screen programmable thermostat)

   AT8100 Thermostat Operating Guide
          (horizontal mount, touch screen programmable thermostat)

   ETV1991 Thermostat Operating Guidelines
          (manual thermostat for DIN Rail mounting for connection to home automation system)



Slab Heat Cable is available direct to trades & home renovators throughout Australia. Amuheat also offer floor heating installation services of Slab Heat Cable across Sydney & Melbourne.

For pricing enquiries upload your plans and submit your enquiry through our website.