Floor Heating ThermostatsCentral to the economic use of all Amuheat' systems is the floor heating thermostats. More than just on and off, the programmable unit offers programs which can be modified to suit the occupants living patterns. Programs allow for control of either air, floor, or both air and floor temperatures, over 4 program periods per day to regulate comfort levels for each zone. |
|
Read more...
|
|
Tile Floor Heating SystemsAmuheat' tile floor heating systems comprise of a single, insulated electric conductive heating element or hot water filled PEX pipes installed beneath the tile floor finish. |
|
Read more...
|
|
Hydronic Floor HeatingOperating the hydronic floor heating system is relatively simple. The floor area is typically warmed to between 25ºC and 28ºC, providing an even distribution of heat at only slightly higher than room temperature. The system is controlled by one or more thermostats which signal the Pump Pack when heat is required. |
|
Read more...
|
|
Electric Slab Floor HeatingElectric slab floor heating uses electric cables embedded in a concrete slab floor to provide home heating. The slab stores the heat, and steadily releases it to provide continuous warmth to your home 24 hours a day. |
|
Read more...
|
|
|
|
|
|
Energy Efficient Electric & Hydronic Floor Heating Systems
Floor Heating Products for Modern Living Cable Mat (in-screed under tile) High performance-low energy design. Amuheat's popular tile floor heating system. Free-form cable attached to a fibreglass mat for in-screed installations for mostly under tile floor finishes. Easily configured on site for any room layout.
Thin Cable Mat (in-tile adhesive) Low wattage on demand floor heating system. Suits renovations with floor build height restrictions as it does not raise floor levels. Features an ultra-thin electric heating cable design for above slab/screed in-tile adhesive installations.
Laminate Panel 14 (under carpet)
Lamiante Panel' 1mm heating element does not add height to the floor, and is not felt through the carpet. Installed directly between the carpet and underlay.
Slab Heat Cable (in polished concrete)For connection to off-peak. Popular for polished concrete floors. For new constructions and renovations as an in-slab heating system.
Speedfit Hydronic (in-screed under tile or in polished concrete topping)Features a 15mm hydronic PEX pipes set out on top of insulation or clipped to the reinforcing steel before the sand cement screed covers the pipe.
Floor Heating ApplicationsTile & Stone
Carpet
Floating Floors
Timber
Polished Concrete
Amuheat is available direct to trades & home renovators throughout Australia including Sydney, Melbourne, Hobart, Adelaide, Perth, Brisbane, Canberra & Newcastle. Installation service support available across Sydney (electric & hydronic) & Melbourne (electric). |
|
|
<< Start < Prev 1 2 3 Next > End >>
|
| Results 27 - 31 of 31 |